For specifiers
Specify NuGreen
with confidence.
Technical performance, environmental data and project-specific support for engineers, producers and infrastructure teams.
Technical foundation
Built on the standards
you already specify to
-
ASTM C1157
Performance Specification for Hydraulic Cement — the NuGreen binder conforms to this performance-based cement standard.
-
ASTM C94
Standard Specification for Ready-Mixed Concrete — NuGreen concrete is produced in accordance with conventional ready-mix practice.
-
CSI MasterFormat 03 30 00
Cast-in-Place Concrete — where NuGreen is specified within standard project documentation.
-
ASTM C39 & durability methods
Compressive strength per ASTM C39; reported durability results per ASTM C666 (freeze-thaw), C1202 (chloride penetration) and C1012 (sulfate), with primary reports being consolidated. C1202 is not used as the principal chloride-transport qualification. Fly ash feedstock meets ASTM C618.
Key reference data
The numbers, classified
by evidence
Environmental
82.6kg CO₂e/m³
Cradle-to-gate GWP · 149 L/m³ production water · 1,248 MJ/m³ primary energy
Typical design range
45–55MPa · 28d
≈ 6,500–8,000 psi — standard production mixes
Rapid early strength
~5,000psi · ~90 min
~9,000 psi reported at 24 hours
Reported high-performance result
13,000+psi · 28d
Reported result set — distinct from the typical design range
Environmental benchmarks
~81%less carbon*
~52% less production water* · ~57% lower primary energy*
Durability
300+freeze-thaw cycles
Reported results · sulfate excellent (C1012) · chloride <1,000 C (C1202, historical)
* Benchmark comparisons are NuGreen calculations vs published NRMCA / PCA industry reference data — methodology. The typical 28-day design range and the reported high-performance result describe different conditions and are never interchangeable. Strength and durability figures are reported results; primary laboratory reports are being consolidated into the substantiation file. Hot-weather performance is under validation with a UAE ready-mix partner; no temperature limits are stated until that programme reports.
Project support
Start with the data sheet
It answers most first-round questions: strength development, durability results, standards conformance and environmental figures. What follows depends on your aggregates, exposure conditions and acceptance criteria — prepared per project, not published.
NuGreen Technical Data Sheet
-
01
Technical data
Strength, durability and material properties for engineering evaluation.
Request technical data -
02
Environmental documentation
Independent LCA data, benchmark methodology and procurement-ready figures.
Request environmental documentation -
03
Project-specific mix data
Matched to your aggregates, exposure conditions and acceptance criteria.
Request project-specific mix data -
04
Specification support
CSI 03 30 00 guidance and specification language for your project documents.
Request specification support -
05
Pilot pour
A trial under your actual materials, mix design and acceptance criteria.
Request pilot pour
Every request reaches the same team. You can also write to info@nugreeninc.com.
Evaluation
Move from data to concrete
The strongest evaluation is a physical one — under your materials, your mix design and your acceptance criteria.